USD$ 34.52 (Dropshippers can also enjoy wholesale prices.)
■See farther, wider, clearer
■Works with most modern cars
■Lasts 5x longer than halogens
■Greatly increases driving safety
■Model and color temperature optional
■Extremely simple to install
■Waterproof, Dustproof, and Shockproof
■Attractive hint of blue and purple in the light
■Comes with everything you need to get started
Operating temperature: -40 to 105℃
Steady state light output: 3000 lumens typical, bulb type dependant
Expected ballast life: Over 3500hrs
Radiated EMI susceptibility: S95/54/EC
Radiated EMI emissions: S95/54/EC
Output wave form: 125Hz square wave
Steady state output power: 35/55W
Open circuit protection: Shut off after 1 second
Shot circuit protection: Shut off after 1 second
Maximum output current: 8A initial light on, 3A after 2 secs
Maximum output power: 80W
Steady state output volts: 85V
Striking voltage: 23000V
Steady state input voltage: 9-16V
Max in rush current: 15A@50ms, 8A at 2 secs, decreasing to steady state within 30 secs
Max steady state input power: 45W(9-16V)
Input turn on: 9V and above
Input turn off: Below 8v
Reverse voltage protection: No damage to ballast with -40V
Efficiency: > 90% during steady status
How to install HID Conversion KIt
Remove the factory headlight bulbs. If necessary, remove the factory headlight bezel as well.
Replace the factory headlight bulbs with HID bulbs. Be careful not to touch the HID bulb glass with bare hands, as the oils on human skin will heat up and damage to the bulb may occur.
Plug the HID bulbs into the ballasts provided with the HID kit. Test the HID ballast wiring for length, as HID lights use special wiring that cannot be extended.
Mount the ballasts as close to the headlight bulbs as possible. Use self-tapping screws and nylon wire ties to mount the ballasts securely to the vehicle. Do not mount the ballasts where they will be exposed to excessive amounts of moisture or heat. Once mounted, connect the factory headlight harness to the ballast to trigger the HIDs.
Test the HIDs for proper operation. It may take up to 10 seconds for the bulbs to illuminate completely. Once correct operation is verified replace the headlight bezel.
* 1* Set HID CONVERSION KIT