Home >> Car & Motorcycle Accessories >> Motorcycle Accessories >> Car-Joy 3D Carbon fiber pattern motorcycle fuel tank fish bone paste paste

Car-Joy 3D Carbon fiber pattern motorcycle fuel tank fish bone paste paste

SKU:A33560000L

3D Carbon fiber pattern motorcycle fuel tank fish bone paste paste.he pressure-activated adhesive allows you to slide and reposition the film until you apply firm pressure. The non-visible air release channels assure a fast, easy and virtually bubble...
Retail Price:
USD$ 19.98
Wholesale Price:
 
Wholesale Price
Quantity 2-78-1920-49≥50
Price USD$ 6.52USD$ 6.51USD$ 6.49USD$ 6.47
 
  • Top Selling
 
  • Overview

Car-Joy 3D Carbon fiber pattern motorcycle fuel tank fish bone paste paste
Features:

Flexible design
bends most motorcycles.


Attaches easily with 
automotive trim tape.
Tape Included
Will not damage paint.
Waterproof and sunproof
Good ventilation
Protect your ride


Car-Joy 3D Carbon fiber pattern motorcycle fuel tank fish bone paste paste

Instructions

1


  • Clean the surface on which the sticker is to be installed. Use rubbing alcohol and a clean rag. As soon as you wipe the surface with the rag, use a second dry rag to buff the surface. This will dissolve and remove any wax that may be on the surface.


  • 2

    Spray water on the surface where the sticker is to be applied. This will allow you to prevent larger stickers from being installed misaligned.


  • 3

    Peel the backing off of the sticker you will be installing. Hold it by the edges so that it is bowed downward in the center.


  • 4

    Position the sticker over the place where you intend to install it and lower your hands so that the middle of the sticker touches the wet surface first. Continue lowering your hands until the entire sticker has made contact with the damp surface. This will prevent the middle of the sticker from bunching up and wrinkling.


  • 5

    Apply the squeegee to the exact center of the sticker, and slowly work in circles around the center point to force the water out from under the sticker. If an air pocket forms, work the bubble out of the edge of the sticker before continuing.


  • 6

    Wipe the sticker gently with the dry rag to adhere it to the surface and to clean excess water out of the edges of the sticker. This will ensure that the carbon fiber sticker adheres to the surface without peeling up.


  •  PACKAGE

    1*3D Carbon fiber pattern motorcycle fuel tank fish bone paste paste