Home >> Computers & Networking >> Computer Components >> PCI-Express Serial ATA I/II Host Controller Card SA3512-1E

PCI-Express Serial ATA I/II Host Controller Card SA3512-1E


This serial ATA host PCI controller card is designed to offer a high performance. Cost effective and reliability solution to user who needs to accommodate storage peripherals with the new serial ATA interface PCI controller card. It can control two i...
Retail Price:
USD$ 37.98
Wholesale Price:
Wholesale Price
Quantity 2-56-1415-39≥40
Price USD$ 22.77USD$ 19.54USD$ 16.31USD$ 12.00
If you want to buy only 1 piece, please alter the quantity in ‘My Cart’.
Note: you could enjoy the wholesale price of this item as long as the item quantity of your order is more than 1.
  • For online wholesaler or distributor, you can buy directly online. If you want to buy more than offered quantities for better price, please click wholesale inquiry.

  • Top Selling
  • Overview


  • Silicon Image SIL 3 x 12A serial ATA host controller chip
  • The PCI controller card is compliant with Serial ATA 1.0 specification
  • Compliant with PCI specification Re 2.2
  • Compliant with PCI IDE specification Re 1.0
  • This PCI controller card supports programmable and EEPROM, FLASH & EPROM loadable PCI class mode
  • Support 2 independent serial ATA channels(1.5Gbps)
  • This PCI controller card supports the serial ATA transfer of 1.5 GB/s (150MB/s)
  • MS Windows 98SE/Me/2000/XP/, Linux
  • Supports co-exist RAID set and Non-RAID HDD
  • Allows HDDs with different sizes to be configured in a RAID set


PCI-Express Serial ATA I/II Host Controller Card SA3512-1E

  • PCI controller card set

PCI-Express Serial ATA I/II Host Controller Card SA3512-1E

  • Back side

PCI-Express Serial ATA I/II Host Controller Card SA3512-1E

  • Single cable port

PCI-Express Serial ATA I/II Host Controller Card SA3512-1E


How to Set Up a PCI Raid Controller Card:

  • Install the drivers that came with your RAID controller card. The drivers come on a CD packaged with the card
  • Shut down your computer and turn off the power supply. Disconnect every cable connected to the computer and then open the case. Open the computer by removing the screws around the outside edge of the rear panel, and then removing the side panel
  • Find an unused PCI slot on your motherboard. PCI slots are the long white rectangles. If the slot has a cover on it, remove it
  • Slide the card firmly into the slot, making sure that the metallic "teeth" on the card line up properly in the slot. Hold the card by the edges, and avoid touching any chips or components on the board
  • Close your computer's case, reconnect all the cables and boot up your computer. During startup you will be prompted with a key to press to enter RAID setup. The specific key will be different with different RAID controller cards and software. Press the designated key
  • Select the hard disks you want to use for the RAID, and which RAID configuration you want. The exact procedure will vary with your controller card and software, but each card offers essentially the same options, and at least RAID types 0 and 1. RAID 0 offers greater access speed, and RAID 1 protects your data by mirroring it across two drives. Select two identical hard drives to use for the RAID
  • Exit setup, and your computer will reboot automatically

Package Included:

  • 1 x Controller Card
  • 1 x CD Driver
  • 1 x ATA Cable
  • 1 x User Manual