Home >> Security & Surveillance >> Surveillance Accessories >> Fusionsea Square Shaped Waterproof Outdoor Security Camera Housing

Fusionsea Square Shaped Waterproof Outdoor Security Camera Housing

SKU:A14710000U

The camera housing is a high quality weather resistant camera housing which is ideal for indoor and outdoor use. Great option for turning an indoor camera into an outdoor camera. It features dustproof, waterproof, wind and sand proof, rain and snow p...
Retail Price:
USD$ 22.78
Wholesale Price:
 
Wholesale Price
Quantity 2-78-1920-49≥50
Price USD$ 6.26USD$ 5.95USD$ 5.64USD$ 5.22
 
Qty:
pieces
If you want to buy only 1 piece, please alter the quantity in ‘My Cart’.
Note: you could enjoy the wholesale price of this item as long as the item quantity of your order is more than 1.
  • For online wholesaler or distributor, you can buy directly online. If you want to buy more than offered quantities for better price, please click wholesale inquiry.

  • Top Selling
 
  • Overview

Specifications:


  • A perfect waterproof housing for camera
  • Use to protect cameras in most conditions
  • Great option for turning an indoor camera into an outdoor camera
  • It has features of dustproof, waterproof, wind and sand proof, rain and snow proof
  • Protects cameras in outdoor environments as well as indoor conditions that may be humid, cold or dusty
  • Ensure full protection to your camera
  • Necessary standard equipment for outdoor camera
  • Dimension: 60 x 54mm / 2.36 x 2.13in
  • Compatibility: 32 x 32mm / 1.26 x 1.26in or 38 x 38mm / 1.5 x 1.5in Cameras
  • Material: Zinc alloy

Detail:

Fusionsea Square Shaped Waterproof Outdoor Security Camera Housing


  • It has features of dustproof, waterproof, wind and sand proof, rain and snow proof


DIY: Waterproof Camera Housing


  • A waterproof camera housing unit will allow pictures or video to be taken under water without the worry of destroying expensive camera equipment. Retail units cost anywhere from $100 to $300, so you may wish for an affordable, easy to make alternative.

What you Need


  • You need two unlubricated clear condoms, a cylindrical cardboard tube approximately or at least bigger then the size of the zoom on the camera (toilet paper or paper towel roll will most likely do), a silica bag (can be pulled out of most vitamin bottles) and wetsuit glue.

What to Do


  • Take a paper towel cardboard roll center and cut 1/4-inch longer then the camera when it is fully zoomed. Place the cardboard cylinder around the zoom to protect the gears of the zoom features. Open a condom. If there is talcum on it or an you were unable to find an unlubricated condom, unroll it and rinse. Take the condom and slowly (so it does not tear or break) roll it over the camera and cardboard cylinder. Drop a silica bag in the condom with the camera (away from the lens) to prevent condensation. Once the entire camera is covered, twist the end of the condom. Use wetsuit glue on the side farthest from the camera and allow it to dry (approximately 5-10 minutes to be safe). Take the second condom, open the package, and repeat the step of rinsing if necessary and putting the condom over the camera and cardboard fixture for a second layer. Again twist the condom/camera to make it airtight and apply wetsuit glue. Be careful to avoid tearing the condom or being rough with the use of the camera when under water.

Package Included:


  • 1 x Camera Housing