Home >> Security & Surveillance >> Surveillance Accessories >> Camesovy IR Infrared Illuminator with 216 Pcs 10 Diameter Lamps IP 65 Waterproof

Camesovy IR Infrared Illuminator with 216 Pcs 10 Diameter Lamps IP 65 Waterproof

SKU:A1414000CX

New IP 65 waterproof IR illuminator with 216 pcs 10 diameter lamps, 120-180m outdoor visible distance, 15 - 45 beam angle, 850nm wavelength. Allow your camera to see in total darkness. This is a simple and effective way of discreetly illuminating an ...
Retail Price:
USD$ 117.98
Wholesale Price:
 
Wholesale Price
Quantity 2-45-910-29≥30
Price USD$ 82.34USD$ 71.65USD$ 60.96USD$ 46.71
 
Qty:
pieces
If you want to buy only 1 piece, please alter the quantity in ‘My Cart’.
Note: you could enjoy the wholesale price of this item as long as the item quantity of your order is more than 1.
  • For online wholesaler or distributor, you can buy directly online. If you want to buy more than offered quantities for better price, please click wholesale inquiry.

  • Top Selling
 
  • Overview

Specifications:


  • Outdoor Visible Distance: 120-180m
  • Number of The Lamps: 216pcsΦ10
  • Beam Angle:15 - 45°
  • Wavelength: 850nm
  • Power Supply: DC12V+AC24V/AC220V optional
  • Model C216-15: Optimum Distance(m): 180m; Angle (°): 15°;  Numbers of LED:  216pcsΦ10mm15°LED
  • Model C216-30: Optimum Distance(m): 150m; Angle (°): 30°;  Numbers of LED:  216pcsΦ10mm30°LED
  • Model C216-45: Optimum Distance(m): 120m; Angle (°): 45°;  Numbers of LED:  216pcsΦ10mm45°LED

 


  • Camesovy IR Infrared Illuminator with 216 Pcs 10 Diameter Lamps IP 65 Waterproof

    New IP 65 waterproof IR illuminator with 216 pcs 10 diameter lamps 

 


  • 120-180m outdoor visible distance

Camesovy IR Infrared Illuminator with 216 Pcs 10 Diameter Lamps IP 65 Waterproof

Camesovy IR Infrared Illuminator with 216 Pcs 10 Diameter Lamps IP 65 Waterproof


About LED Infrared Light:


  • IR (infrared) sensors detect infrared light. The IR light is transformed into an electric current, and this is detected by a voltage or amperage detector.A property of light-emitting diodes (LEDs) is that they produce a certain wavelength of light when an electric current is applied--but they also produce a current when they are subjected to the same wavelength light
  • A pair of IR LEDs can be used as motion detectors. The first IR LED is wired to emit LED and the second LED is wired to transmit a signal when it receives an IR input. When an object comes within range of the emitted IR, it reflects the IR back to the receiving LED and produces a signal. This signal can be used to open sliding doors, turn on a light or set off an alarm

How to Test IR LEDs?


  • Remote IR LED:
  • Insert new batteries into the remote you want to test
  • Point the front of the remote where the LED is attached at the lens of a digital camera. Turn the digital camera on. A cell phone camera will also work for this
  • Press a button on the remote. If the LED is working properly, you will see a series of bright flashes from the bulb in the camera's LCD screen
  • Individual LED Bulb:
  • Calculate the resistor ohms needed to connect the IR LED bulb to a 9V battery. Resistors limit the amount of electricity passed to the LED. If too much electricity is allowed to pass, it will burn out the bulb
  • To calculate the resistor ohms needed for the LED, subtract the LED's forward volts from the battery's voltage, then divide that number by the amps needed to power the LED. The forward voltage should be listed on the LED's packaging. For example, if your LED requires 40mAh and has a forward voltage of 4v, and you're going to connect the LED to a 9V battery, the equation would look like this: (12volts - 4volts) / 0.04 = 200ohm. In this example, the LED would require a 200ohm resistor in order to run off a 9V battery
  • Twist one end of the resistor onto the longer of the LED's two wires; the longer wire is the positive wire, while the shorter wire is the ground. Clip an alligator clip from the other end of the resistor to the positive terminal on the 9V battery. Clip another alligator clip from the ground LED wire to the negative terminal on the battery
  • Look at the LED light bulb using a digital camera. The bulb is functional if it is glowing on the camera's screen

Package Included:


  • 1 x IP 65 Waterproof IR Illuminator with 216 Pcs 10 Diameter Lamps